Making a Corinthian crest

[Athena Areias]

I used ANSI #8 x 3/4" long Pan Head brass Machine Screws. The inset is matched to the Screw size (can't remember). The hole for the inset was a little less than 1/4" diameter. Don't forget to drill deeper with a pilot hole for the screw length itself. Mine passes all the way through the inset. Hope that helps. Do the holes (slip fit) in the helmet first. Then match the box to those holes (pencil marks). The holes were about 9 or 10 inches apart. You will have to pull one helmet hole (probably the rear one) into a slight slot. You need a liitle play so the box pulls tight to the helmet. A woodworking hobby shop will set you right. Good luck.

Don't know nuthin' about soldering brass or birthin' babies.