Well I was finally able to get back to work on my helmet
I decided against soldering and replaced the rivets holding the brow guard, there just wasnt enough rivet on the back to make it tight no matter how how much it was peened.
now its firmly attached and dosent swivel up and down even if pulled on with some force.
on the cheeck plates the hinges were bent outward and the middle part of the E? were rolled in a bit.
Is there anything else that should be done?
I decided against soldering and replaced the rivets holding the brow guard, there just wasnt enough rivet on the back to make it tight no matter how how much it was peened.
now its firmly attached and dosent swivel up and down even if pulled on with some force.
on the cheeck plates the hinges were bent outward and the middle part of the E? were rolled in a bit.
Is there anything else that should be done?
Shawn Hamburg