07-03-2008, 11:58 AM
That is a good point David. What I found was that I just could not get the width required for the palmette. Speaking with Matt Lukes though I think I started off with too thin a piece of brass stock.
I also wondered if they were actually rough cast and then finally hammered into shape and finished off.
I also wondered if they were actually rough cast and then finally hammered into shape and finished off.
Sulla Felix
AKA Barry Coomber
Moderator
COH I BATAVORVM MCRPF
AKA Barry Coomber
Moderator
COH I BATAVORVM MCRPF