07-27-2012, 03:38 PM
About the discussion of the hole in the front for the visor, please see we are using cast visor for the helmet, and it may not be possible to cast thinner than this. We already receive some complaints about these breaking, casting it thinner would only elevate such complaints. The hole is based on the thickness of the visor, and is normally not really visible, once the visor is setup.
Rado, another problem I see in not having a slot to hold the visor, is that it can also fall below. It will be difficult to control where it is placed in production. With the slot, they all come in exactly the same place.
I am open to suggestions, if what else can be done on this.
Gagan
Rado, another problem I see in not having a slot to hold the visor, is that it can also fall below. It will be difficult to control where it is placed in production. With the slot, they all come in exactly the same place.
I am open to suggestions, if what else can be done on this.
Gagan