07-12-2012, 06:46 PM
If I might ask a question, Why is the crest holder on the re-production set at 90 degrees to that of the original helmet ?
For if the crest holder to be used on the re-production were of the number 3 type as shown by Rado it would work much better with the slot in a transverse position as on the original.
In fact after looking again at the number 3 type crest holder the locating bar at the bottom should be at an angle of 90 degrees to that shown if it is to be uesd as a centurians crest holder.
For if the crest holder to be used on the re-production were of the number 3 type as shown by Rado it would work much better with the slot in a transverse position as on the original.
In fact after looking again at the number 3 type crest holder the locating bar at the bottom should be at an angle of 90 degrees to that shown if it is to be uesd as a centurians crest holder.
Brian Stobbs
