11-19-2009, 11:34 AM
This is the first upper part of the Locket plate which I basically traced onto flat sheet brass and then punched and filed for the cut outs, and then used shaped masonry nails for finer engraving /punching the design.
And here is the completed Lcket plate in position on the wooden scabbard
And a close up
And here is the completed Lcket plate in position on the wooden scabbard
And a close up
Sulla Felix
AKA Barry Coomber
Moderator
COH I BATAVORVM MCRPF
AKA Barry Coomber
Moderator
COH I BATAVORVM MCRPF