Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
hamata assembly
#1
:?:
I am new to using a message board so I am hoping that this is going out to everyone. I am doing a hamata using riveted chainmail about 8mm I.D.. What is the best way to put this together to form a chainmail shirt? At this point I feel kind of dumb for attempting it. Thank you for any help.



Will
Reply
#2
Have you seen Matt Amts page?

http://www.larp.com/legioxx/hamata.html
"...quemadmodum gladius neminem occidit, occidentis telum est."


a.k.a. Paul M.
Reply
#3
-moving it to Reenactment and Reconstruction-
Greets!

Jasper Oorthuys
Webmaster & Editor, Ancient Warfare magazine
Reply
#4
Go to:

[url:tsae7gu5]http://www.mailleartisans.org/articles/articledisplay.cgi?key=12734[/url]

I've put this project aside, but will restart using smaller diameter wire and maybe round rivets. I need to experiment abit with the tooling for round rivets as very little on the methods has been published.
Titus Licinius Neuraleanus
aka Lee Holeva
Conscribe te militem in legionibus, vide mundum, inveni terras externas, cognosce miros peregrinos, eviscera eos.
<a class="postlink" href="http://www.legiotricesima.org">http://www.legiotricesima.org
Reply
#5
when I bought a batch of rivet rings with rivets a few years back, I knew of a dealer selling the triangle ones who also sold a rivetting tool with them. However, I bought round rivet rings. when I asked about a tool, I was told to just squash them between a pair of pliers (or for those weaker in forearm like myself, I've found vise-grips are a huge help).

Low and behold - I was told right. I did however find, that drilling a small indentation into both sides of the pliers helps prevent slip ups. I had a couple that bent over more than "peened", and decided to scrap them after drilling into the jaws.
Marcus Julius Germanus
m.k.a. Brian Biesemeyer
S.P.Q.A.
Reply
#6
Quote:drilling a small indentation into both sides of the pliers helps prevent slip ups

And don't forget to use the longest handled pliers that can be used effectively. You can alos grind the tip of the pliers down so it's a little narrower, so as to make the fit easier, should you have to make a repair later.
M. Demetrius Abicio
(David Wills)

Saepe veritas est dura.
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Hamata assembly to achieve a shirt Hamata 8 2,676 07-17-2007, 12:11 AM
Last Post: Chuck Russell

Forum Jump: