04-06-2007, 07:20 PM
Salve,
As far as purchasing brass sheets, I was able to pick up a 3 foot by 1 foot sheet of .040 (18 gauge) brass for $34.00.
Larger I'm sure would be more but, EBay is a pretty good source.
I brought it to fabricate the visor (brow) piece for my Attic Helmet. I was going to use the left over to make plates for my belt. I'm most likely going to weld very thin " artist's medium embossing brass" to the thicker 18g brass, the thin brass would be embossed but, that's a different thread. :roll:
As far as purchasing brass sheets, I was able to pick up a 3 foot by 1 foot sheet of .040 (18 gauge) brass for $34.00.
Larger I'm sure would be more but, EBay is a pretty good source.
I brought it to fabricate the visor (brow) piece for my Attic Helmet. I was going to use the left over to make plates for my belt. I'm most likely going to weld very thin " artist's medium embossing brass" to the thicker 18g brass, the thin brass would be embossed but, that's a different thread. :roll:
Vale!
Antonivs Marivs Congianocvs
aka_ANTH0NY_C0NGIAN0
My ancient coin collection:
[url:3lgwsbe7]http://www.congiano.com/MyCoins/index.htm[/url]
Antonivs Marivs Congianocvs
aka_ANTH0NY_C0NGIAN0
My ancient coin collection:
[url:3lgwsbe7]http://www.congiano.com/MyCoins/index.htm[/url]