02-17-2015, 03:29 PM
Thank you. The best thing I have at the moment is an unmounted hacksaw blade, which is just a little shorter than the sword blade, so if the problem exists toward the tip of the scabbard (which may be the case -- feeling with the hacksaw blade hasn't detected any significant inward protrusions so far), it may not work. I can probably borrow a scrap from the foundry at Bucks that'll do the trick. Unfortunately, it was made to fit a sword that's little more than a long butterknife, so a rasp won't fit.
Dan D'Silva
Far beyond the rising sun
I ride the winds of fate
Prepared to go where my heart belongs,
Back to the past again.
-- Gamma Ray
Well, I'm tough, rough, ready and I'm able
To pick myself up from under this table...
-- Thin Lizzy
Join the Horde! - http://xerxesmillion.blogspot.com/
Far beyond the rising sun
I ride the winds of fate
Prepared to go where my heart belongs,
Back to the past again.
-- Gamma Ray
Well, I'm tough, rough, ready and I'm able
To pick myself up from under this table...
-- Thin Lizzy
Join the Horde! - http://xerxesmillion.blogspot.com/