Posts: 137
Threads: 14
Joined: Jun 2009
Reputation:
0
Looking for a good source for solid flat washers with a similar aspect ratio to 16 ga round wire. With all the maille coming out of India these days one would think these things would be plentiful.
Non mihi, non tibi, sed nobis
Joe Patt (Paruzynski)
Milton, FL, USA
Posts: 479
Threads: 16
Joined: Oct 2009
Reputation:
9
AgrimensorLVCIVS FLAVIVS SINISTER
aka Jos Cremers
member of CORBVLO
ESTE NIX PAX CRISTE NIX
Posts: 137
Threads: 14
Joined: Jun 2009
Reputation:
0
Thanks, I am planning to make my own riveted ones from scratch, but this is an option.
Non mihi, non tibi, sed nobis
Joe Patt (Paruzynski)
Milton, FL, USA
Posts: 766
Threads: 72
Joined: Jun 2011
Reputation:
3
Hi all
After seeing this thread it got the grey matter working, then the grey matter failed me:
How big an area does 1kg...thats 2.2lbs UK...cover? How many kg are needed for a chest size of 38 inches for example, how many rings is that?
It would be devastating if one ran out of rings on the last line for example.
My own came from Alhamd and wieghs 9kg to fit a chest of me at 36 but the Hamata is 42 and its tight.
Maybee a "PROPER" size chart could be made up for mail shirts both off the shelf and DIY...it would help.
Kevin
Kevin
Posts: 137
Threads: 14
Joined: Jun 2009
Reputation:
0
Quote:Hi all
After seeing this thread it got the grey matter working, then the grey matter failed me:
How big an area does 1kg...thats 2.2lbs UK...cover? How many kg are needed for a chest size of 38 inches for example, how many rings is that?
It would be devastating if one ran out of rings on the last line for example.
My own came from Alhamd and wieghs 9kg to fit a chest of me at 36 but the Hamata is 42 and its tight.
Maybee a "PROPER" size chart could be made up for mail shirts both off the shelf and DIY...it would help.
Kevin
The Ring Lord has a
calculator set up for number of rings per shirt depending on body size and ring size/aspect ratio, from there you can find out mass.
Non mihi, non tibi, sed nobis
Joe Patt (Paruzynski)
Milton, FL, USA
Posts: 137
Threads: 14
Joined: Jun 2009
Reputation:
0
The battle merchant says a 20cm by 20cm section of their 6mm shirt weighs approximately .25kg, so using area of a cylinder as rough estimate:
My chest is 48", add 2" for subarmalis, from top of shoulder to hip is 30"
50*2.54*π*30*2.54 = 11,969 cm^2 divided by 400 = 30 20 cm x 20 sections = 7.5kg
Add another 8 sections for the doubler and I'm looking at about 9.5kg.
Almost as much as they charge for a custom built hamata in my size.
Non mihi, non tibi, sed nobis
Joe Patt (Paruzynski)
Milton, FL, USA