06-10-2008, 10:11 PM
Peroni,
Is that for all the fragments or just that one. Thicknesses varied amongst the sheet metals used. :?:
I believe that thikness would be where the plates overlap in which case obviously you get 2mm or close to it. But how about each individual plate? If each plate is 2mm, then at the overlap it would be 4mm.
hock:
Again, the manica I am having made by Matt Lukes, does not have 2mm thick plates. At the overlap they are about 2mm. I doubt that someone with the knowlege of Lukes would construct a piece of armor for a client using the incorrect thickness and proportions. :wink:
Is that for all the fragments or just that one. Thicknesses varied amongst the sheet metals used. :?:
I believe that thikness would be where the plates overlap in which case obviously you get 2mm or close to it. But how about each individual plate? If each plate is 2mm, then at the overlap it would be 4mm.
hock: Again, the manica I am having made by Matt Lukes, does not have 2mm thick plates. At the overlap they are about 2mm. I doubt that someone with the knowlege of Lukes would construct a piece of armor for a client using the incorrect thickness and proportions. :wink:
"You have to laugh at life or else what are you going to laugh at?" (Joseph Rosen)
Paolo
Paolo
