01-04-2008, 12:08 AM
Salve brothers,
I am getting ready to make a balteus.
I was wondering if any of you could grab some measurements off of your concentric circle plates.
I believe that the base plate is about 2" x 2.5", so what is the circumference of the largest circle as well as the one beside that (never mind the lump in the nipple... I mean middle :wink:
I need this so I get the right sized steel tubes for dies.
I have attached a pic of one of Clang's for reference.
Thanks in advance!
I am getting ready to make a balteus.
I was wondering if any of you could grab some measurements off of your concentric circle plates.
I believe that the base plate is about 2" x 2.5", so what is the circumference of the largest circle as well as the one beside that (never mind the lump in the nipple... I mean middle :wink:
I need this so I get the right sized steel tubes for dies.
I have attached a pic of one of Clang's for reference.
Thanks in advance!
Q. ARTORIVS CORVINVS
aka: Phillip Vautour
"Rome is but a wilderness of tigers, and tigers must prey."
<a class="postlink" href="http://rubicon.dyndns.org/legioxxi">http://rubicon.dyndns.org/legioxxi
aka: Phillip Vautour
"Rome is but a wilderness of tigers, and tigers must prey."
<a class="postlink" href="http://rubicon.dyndns.org/legioxxi">http://rubicon.dyndns.org/legioxxi
