Building a seg: width of gridle plates and overlap
|
Building a seg: width of gridle plates and overlap
|
|
10-22-2004, 12:47 PM
I'm experimenting with cardboard mockups for a replacement torso section for my Corbridge A segmentata (8 gridle plates). Matt Amt says to use 2 and 1/4 inch wide gridle plates, but for my torso, this seems to make a torso section that is too short (I'm 6'2" tall). 2 and 1/2 inch wide plates seem to work better. I've been assuming a 3/8 inch vertical overlap. Too little, or too much? This is what my Indian made seg appears to use. <p></p><i></i>
|
|
« Next Oldest | Next Newest »
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Balteus Width | Gatorsailor | 13 | 2,542 |
03-15-2013, 05:45 AM Last Post: Gatorsailor |
|
| Amount of overlap on segmentata shoulder lames | kazeryu | 29 | 6,047 |
08-06-2011, 08:59 PM Last Post: kazeryu |
|
| Newstead Lorica Girth Plate Overlap - Left or Right? | Anonymous | 1 | 1,252 |
03-01-2005, 03:24 AM Last Post: Anonymous |
|
