Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Seeking how to on Imperial Gallic G wooden crest
#2
I'm always happy to see someone trying to make their own kits and looking for the most authentic look. The crest is roughly just half of a circle, about 1 1/4" thick and I used a standard 2X8 to cut from, which is 1 1/2" wide.
I used a jig saw to cut out the two circle lines and then squared off the ends.
The holes for the hair were drilled with a 1/4" drill bit. I spaced the holes evenly across the top and going length wise, ending up with 99 holes. I did stagger the center holes to prevent them from being too close together and that way they will fill in better. You should always mark the spots and make corrections before trying to start drilling.
Drilling the holes will be your biggest challenge, so you want to take your time ( I got it right on the third try) and punch your marks and predrill with a smaller bit. The larger bit will try to walk on you if you try it first, ruining your work.
As to the type of wood, that will be your call. I used American SYP, as mine is covered anyway.
If you want examples and patterns, just Google what you want and you will find several sites with measurements and sketches, which will mirror the information I gave above.
The best of luck with your work and I hope you will attempt to build more of your kit.
Manius Acilius Italicus
Bob Cherry
Manius Acilius Italicus
Reply


Messages In This Thread
Seeking how to on Imperial Gallic G wooden crest - by Robert Cherry - 07-13-2013, 02:33 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  6052N Imperial Gallic G 7trumpets 2 4,004 01-07-2015, 12:46 AM
Last Post: Sextus Saturninus
  Imperial Gallic F 08 LUCIUS ALFENUS AVITIANUS 9 7,839 11-07-2007, 06:21 PM
Last Post: Praefectusclassis
  Imperial Gallic G in Traian times? Titus Martius 2 5,229 06-02-2006, 11:13 AM
Last Post: Titus Martius

Forum Jump: