Reshaping a helmet?
|
Reshaping a helmet?
|
11-16-2012, 04:09 AM
Perhaps you could use a large woodpress/woodclamp used to glue furniture, one of those things with a part that slides? That is what I would use. I just had a look at my two Deepeeka helmets, but the browguards on those seem not to have been cast. Forging them is a lot simpler then casting them, so I presume they were made by forging.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Reshaping a helmet? - by Quintus Antonius - 11-15-2012, 04:17 AM
Reshaping a helmet? - by Thorsten - 11-15-2012, 02:53 PM
Reshaping a helmet? - by Marc Byrne - 11-15-2012, 06:01 PM
Reshaping a helmet? - by Quintus Antonius - 11-15-2012, 11:57 PM
Reshaping a helmet? - by Flavivs Aetivs - 11-16-2012, 12:33 AM
Reshaping a helmet? - by kevin mills - 11-16-2012, 01:46 AM
Reshaping a helmet? - by Jvrjenivs - 11-16-2012, 01:50 AM
Reshaping a helmet? - by Robert - 11-16-2012, 04:09 AM
Reshaping a helmet? - by Robert Cherry - 11-25-2012, 08:38 AM
Reshaping a helmet? - by Crispianus - 11-25-2012, 01:49 PM
Reshaping a helmet? - by Virilis - 11-25-2012, 02:05 PM
|
