06-15-2008, 05:58 PM
(This post was last modified: 01-26-2018, 05:55 PM by brennivs - tony drake.)
Now I didnt have time to do the apex profile so I will do it later and useing files ect the smooth down. It is the same process as the leaf but you are just flattening the metal down from the edge to the centre.
This is what you end up with
As you can see the are very few marks left, Ow I fought to mention once you have sanded down both sides of the blade you can then move onto the centre line and work it into the blade D
Regards Brennivs
This is what you end up with
As you can see the are very few marks left, Ow I fought to mention once you have sanded down both sides of the blade you can then move onto the centre line and work it into the blade D
Regards Brennivs
Woe Ye The Vanquished
Brennvs 390 BC
When you have all this why do you envy our mud huts
Caratacvs
Centvrio Princeps Brennivs COH I Dacorivm (Roma Antiqvia)
Brennvs 390 BC
When you have all this why do you envy our mud huts
Caratacvs
Centvrio Princeps Brennivs COH I Dacorivm (Roma Antiqvia)