11-04-2002, 08:45 PM
Getting heat near a plastic figure is a very unwise idea. The amount of heat needed to melt away a blob will surely melt small detail a little further on the figure. Twisting may damage the figure, especially the softplastic ones, they twist all over!<br>
Your best shot is using a sharp side cutter, cutting close to the figure. The rest may be cut off with a sharp modelling knife. <p>Greets<BR>
<BR>
Jasper</p><i></i>
Your best shot is using a sharp side cutter, cutting close to the figure. The rest may be cut off with a sharp modelling knife. <p>Greets<BR>
<BR>
Jasper</p><i></i>