07-25-2004, 07:37 PM
Hello All,<br>
<br>
I am a complete novice to metalworking and have a question.<br>
I ran a search at Arador but could not find an answer. What tools did they use to punch rivit holes in sheet metal? I tried a center punch for my first attempt and the result was ghastly. Second, the drill, which produced the desired result, however to be honest, I'd rather use the original technique.<br>
<br>
Thanks,<br>
John <p></p><i>Edited by: <A HREF=http://p200.ezboard.com/bromanarmytalk.showUserPublicProfile?gid=jflaherty@romanarmytalk>JFlaherty</A> at: 7/25/04 9:48 pm<br></i>
<br>
I am a complete novice to metalworking and have a question.<br>
I ran a search at Arador but could not find an answer. What tools did they use to punch rivit holes in sheet metal? I tried a center punch for my first attempt and the result was ghastly. Second, the drill, which produced the desired result, however to be honest, I'd rather use the original technique.<br>
<br>
Thanks,<br>
John <p></p><i>Edited by: <A HREF=http://p200.ezboard.com/bromanarmytalk.showUserPublicProfile?gid=jflaherty@romanarmytalk>JFlaherty</A> at: 7/25/04 9:48 pm<br></i>
