|
Steel Umbo?
|
10-02-2007, 10:45 PM
No, if you've made a flat umbo, it's nearly impossible to correct it without curving the backplate AND adding some dish to the sides of the bowl. The curve of the umbo will not allow the back plate to curve smoothly and neatly. Tried that one time, then had the tools built.
M. Demetrius Abicio
(David Wills) Saepe veritas est dura. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Steel Umbo? - by Nerva - 10-01-2007, 12:51 PM
Re: Steel Umbo? - by Jvrjenivs - 10-01-2007, 01:22 PM
Re: Steel Umbo? - by Peroni - 10-01-2007, 01:48 PM
Re: Steel Umbo? - by Crispvs - 10-01-2007, 06:10 PM
Re: Steel Umbo? - by Gaius Julius Caesar - 10-01-2007, 07:41 PM
Re: Steel Umbo? - by M. Demetrius - 10-01-2007, 07:45 PM
Re: Steel Umbo? - by Gaius Julius Caesar - 10-01-2007, 07:49 PM
Re: Steel Umbo? - by Primvs Pavlvs - 10-01-2007, 08:01 PM
Re: Steel Umbo? - by M. Demetrius - 10-01-2007, 08:14 PM
Re: Steel Umbo? - by Jvrjenivs - 10-01-2007, 08:15 PM
Re: Steel Umbo? - by Peroni - 10-01-2007, 08:16 PM
Re: Steel Umbo? - by M. Demetrius - 10-01-2007, 08:22 PM
Re: Steel Umbo? - by QVINTVS ARTORIVS CORVINVS - 10-02-2007, 08:13 PM
Re: Steel Umbo? - by M. Demetrius - 10-02-2007, 10:45 PM
Re: Steel Umbo? - by QVINTVS ARTORIVS CORVINVS - 10-02-2007, 11:19 PM
Re: Steel Umbo? - by M. Demetrius - 10-02-2007, 11:30 PM
Re: Steel Umbo? - by QVINTVS ARTORIVS CORVINVS - 10-02-2007, 11:33 PM
|
