05-18-2007, 01:11 PM
As to brass edging, I am not sure where you could buy it ready made, but I edged mine in brass using the instructions found here:
http://www.florentius.com/scutumedging.htm
I have attached a photo of my scutum. I used .020" or .5mm brass sheet for mine, cut in accordance with the instructions from the website.
I bought a 20cm x 20cm piece of steel, 3/8" thick, for a cheap price to make rounded corners as well. I used square corners on mine, and made a rim for another member of our legio with rounded corners using this jig.
I also have a large number of photos of the process that might be helpful.
Regards,
Edge
http://www.florentius.com/scutumedging.htm
I have attached a photo of my scutum. I used .020" or .5mm brass sheet for mine, cut in accordance with the instructions from the website.
I bought a 20cm x 20cm piece of steel, 3/8" thick, for a cheap price to make rounded corners as well. I used square corners on mine, and made a rim for another member of our legio with rounded corners using this jig.
I also have a large number of photos of the process that might be helpful.
Regards,
Edge
Gaius Aurelius Calvus
(Edge Gibbons)
Moderator
Rules for Posting
LEG XI CPF
<a class="postlink" href="http://www.11thlegion.com">http://www.11thlegion.com
"Mens est clavis victoriae."
(Edge Gibbons)
Moderator
Rules for Posting
LEG XI CPF
<a class="postlink" href="http://www.11thlegion.com">http://www.11thlegion.com
"Mens est clavis victoriae."