01-26-2005, 01:42 PM
Jasper, Tarbicus,<br>
<br>
thank You for Your friendly suggestions, I couldn't answer earlier. Scaling down with a copier resulted in an unreadable inscription, the place is too limited. Also I made an early attempt of constructing my own letter tool with thin sheet metal, but the result was not convincing. Perhaps a very small screw driver is the solution, Tarbicus, but I would have to break the meanwhile hardened inscription range again ... I'll hold You up to date.<br>
<br>
BTW, Jim, very fine photo of You in the 'Roman soldier impression'-topic, I always like to contact people with a sense for humor.<br>
<br>
Greets - Uwe <p></p><i></i>
<br>
thank You for Your friendly suggestions, I couldn't answer earlier. Scaling down with a copier resulted in an unreadable inscription, the place is too limited. Also I made an early attempt of constructing my own letter tool with thin sheet metal, but the result was not convincing. Perhaps a very small screw driver is the solution, Tarbicus, but I would have to break the meanwhile hardened inscription range again ... I'll hold You up to date.<br>
<br>
BTW, Jim, very fine photo of You in the 'Roman soldier impression'-topic, I always like to contact people with a sense for humor.<br>
<br>
Greets - Uwe <p></p><i></i>
Greets - Uwe