05-06-2008, 01:21 PM
Greetings!
I am currently experimenting making a curved auxillary shield using Matt's design for a shield press. Between starting a business, working and raising a family, I can't spend as much time on the project as I'd like.
So just a few thoughts based on said experiments: When making a curved aux shield, DOUBLE the number of shaped cross pieces so one will not get a "wavy" edge to the shield. A bit more work, but initial results are promising. Good Luck Tiberius.
Vitruvius
a.k.a. Larry Mager
I am currently experimenting making a curved auxillary shield using Matt's design for a shield press. Between starting a business, working and raising a family, I can't spend as much time on the project as I'd like.
So just a few thoughts based on said experiments: When making a curved aux shield, DOUBLE the number of shaped cross pieces so one will not get a "wavy" edge to the shield. A bit more work, but initial results are promising. Good Luck Tiberius.
Vitruvius
a.k.a. Larry Mager
Larry A. Mager